Radiators Caps Bangor ME

This page provides relevant content and local businesses that can help with your search for information on Radiators Caps. You will find informative articles about Radiators Caps, including "Radiators Caps Are Important Too". Below you will also find local businesses that may provide the products or services you are looking for. Please scroll down to find the local resources in Bangor, ME that can help answer your questions about Radiators Caps.

Carquest
(207) 941-1480
1193 Hammond St
Bangor, ME
Services
Auto Parts

Carquest of Bangor Hammond St
(207) 941-1480
1193 Hammond St
Bangor, ME
Services
Auto Parts

Carquest Auto Parts
(207) 945-5418
155 Perry Rd
Bangor, ME
Services
Auto Parts

VIP Parts Tires Service
(207) 989-1280
500 Wilson St
Brewer, ME
Services
Auto Parts,Brake Repair,Clutch Repair,Emissions Testing,Engine Repair,Retail Tire,Service Stations

Carquest Auto Parts of Old Town
(207) 827-4445
481 Stillwater Ave
Old Town, ME
Services
Auto Parts

Carquest of Bangor Main St
(207) 942-6734
317 Main St
Bangor, ME
Services
Auto Parts

Carquest Distribution Center
(207) 262-9700
155 Perry Rd
Bangor, ME
Services
Auto Parts

Carquest
(207) 991-9700
685 Wilson St
Brewer, ME
Services
Auto Parts

Carquest of Brewer
(207) 991-9700
685 Wilson St
Brewer, ME
Services
Auto Parts

VIP Parts Tires and Service
(207) 827-7012
947 Stillwater Ave
Old Town, ME
Services
Auto Parts,Brake Repair,Clutch Repair,Emissions Testing,Engine Repair,Retail Tire,Service Stations

Radiators Caps Are Important Too

By Bill Siuru   

While radiator caps look simple and do not cost much, they are critical for a properly Operating cooling system. A faulty cap can result in overheating, loss of coolant or major engine damage, so it is important that it is checked periodically and replaced if necessary.

To prevent overheating and coolant loss, cooling systems are pressurized raising the coolant's boiling point about 3-degrees F for each additional psi above atmospheric pressure. The cooling system is pressurized as the engine warms up and the coolant expands. The radiator cap's pressure relief valve allows pressure to build up to a specified level, then lets excess pressure to escape. In an "open" systems found in older vehicles, excess pressure escapes to the atmosphere through an overflow tube. As the system cools, air enters through the overflow tube and coolant is lost. Therefore, "closed" or reservoir cooling systems are used in later model vehicles. Here, as the coolant expands it goes through the over- flow tube into a reservoir. The radiator cap now serves as a vacuum relief and siphon valve allowing coolant to be siphoned back into the radiator as the engine cools and the coolant contracts.

Radiator caps also serve as pressure relief valve to prevent excessive pressure in the cooling system after the engine is turned off. Unchecked high pressure could cause damage to the radiator, heater core, hoses or water pump seal. The pressure cap also prevents radiator hoses and tanks from collapsing due to the partial vacuum which would be created if air was unable to enter.

Check the radiator cap during routine maintenance, when coolant is tested or when coolant is replaced. Check only when the engine is cool. Then with the engine off, place a rag over the cap and remove it. Turn it counterclockwise about 1/4-turn until it reaches the safety stop. Allow all pressure to vent before removing the cap by pressing down and turning it counter-clockwise. On some vehicles, the radiator cap is located on the overflow reservoir.

Once the cap is removed, Pressure test the cap noting the maximum pressure when the cap valve opens. Caps come in a variety of pressure ranges: 4-pound caps (3-5 lbs.), 7- pound caps (6-8 lbs.), 13- or 14-pound caps (12-16 lbs.) and 15- or 16-pound caps (14-18 lbs.). The cap should be replaced if it fails to hold the rated pressure for one minute. Using a cap with the wrong pressure rating can cause over pressurization or...

Click here to read the rest of this article from New Car Buying Guide